Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

The OBD-II UART Adapter for Arduino works as a data bridge between vehicle's OBD-II port and the serial UART of Arduino, used for reading out data such as speed or engine RPM from car's ECU computer. With dedicated Arduino library, it is extremely simple to perform a readout on Arduino. The adapter embeds a MPU-6050 accelerometer/gyro/temperature sensor module inside with I2C interface. The accelerometer can be used for measuring a car's acceleration and steering G-force. The gyroscope can be us

Error 5001 with MPU6050 and Servo write LINX - Page 2 - NI Community

Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

MPU6050 - GY 521 with Arduino UNO R3 stuck at Initializing I2C devices - Sensors - Arduino Forum

motors interferencing I2C communication with MPU-6050 - Sensors - Arduino Forum

OBD-II / CAN Interface, obd

MPU6050 failed connection ! - Sensors - Arduino Forum

5' OBD-II Memory Cord (Blue-Point®), EECS5MEM, obd 2

known as an operating system for coders

known as an operating system for coders

Freematics Vehicle Data logger V4, DFRobot TEL0105

Freematics OBD-II UART Adapter V1 (for Arduino)